Every time that I do a clean install on my machine it takes a few hours till I get to point where I was before formatting it, install all packages, select themes, icons, fonts, install IDEs, extensions and so on. After doing it a few times I came to the conclusion that I would save time by spending time automating this chore, and as a result, I could tinker a little more with my system and not worry about spending a weekend re-installing everything (which have happened more time that I'd like to remember).
So after a few attempts using python and bash I ended with many files and keep everything organized and concise turned out to be more tedious than the setup itself. So there comes Ansible. It is an enterprise-graded software used to automate tasks. It has A LOT OF features and it can be really helpful if you're a sysadmin but for now we're going to focuson Ansible Pull and Playbooks . As better described:
[Ansible-Pull] is used to up a remote copy of ansible on each managed node, each set to run via cron and update playbook source via a source repository. This inverts the default push architecture of Ansible into a pull architecture, which has near-limitless scaling potential. Playbooks are Ansible’s configuration, deployment, and orchestration language. They can describe a policy you want your remote systems to enforce, or a set of steps in a general IT process. (source)
The goal is to pull and run a playbook remotely using a git repository. The
playbook will describe the tasks needed to setup our machine from scratch.
But first lets tinker a bit a with playbooks locally with ansible-playbook,
to do so we need to add localhost to ansible's hosts list. Add it to
/etc/ansible/hosts:
[all]
localhost
As an experiment we're going to write a asks to install vim. Currently, I'm using Fedora thus we going to use dnf modeule to install packages, but if you're using another distribution look for a equivalent module like apt module for Ubuntu. The playbook to install is quite simple:
# main.yaml
- hosts: all
tasks:
- name: install vim
dnf:
name: vim
state: latest
To run a playbook use the command ansible-playbook commando to run main.yml direct from disk, do to so just run the following command:
sudo ansible-playbook --connection=local main.yml
After a few seconds, vim will be installed on your machine.
PLAY [all] *************************************************************
TASK [Gathering Facts] *************************************************
ok: [localhost]
TASK [install vim] *****************************************************
ok: [localhost]
PLAY RECAP *************************************************************
localhost : ok=2 changed=0 unreachable=0 failed=0
This is the first step, next part we shall create a more complex playbook and setup repository to run it remotely using ansible-pull.